Hi all! I am trying to figure out which version of Oracle 9i I should use for Axapta 3.0SP3 or SP4. I sent a question to Microsoft and the answer I got was a link to the german MBS site: http://www.microsoft.com/germany/businesssolutions/axapta/systemanforderungen.mspx The site is in german but it states that the Oracle version should be 22.214.171.124. BUT: A little bit above you can read: Microsoft Axapta 3.0 Service Pack 2 Therefore I phoned them today and asked about SP3 and SP4. The answer was: there has been no change which Oracle version to use, so it is still 126.96.36.199. Well, I was googling afterwards and found this site from MBS Russia: http://www.microsoft.com/Rus/BusinessSolutions/Solutions/Axapta/Scaling/Platform.mspx Here, at the bottom of the site you can read in the “3.0 SP3” line: 188.8.131.52 !!! Well, my russian is not too good but I would say that this MBS office says you can use Oracle 184.108.40.206 for Axapta 3.0 SP3. Questions to all of you now: 1. Did you ever get any information about which Oracle version to use for Axapta 3.0 SP3 and Axapta 3.0 SP4? 2. Which version of Axapta and Oracle are you running ??? Thank you all!
HI Helmut The rule is this. You can run any of the 9I with Axapta 3.0… We unfortunately do test and verify all service packs and mini packs from Oracle, but as Windows update, it is recommended to run the newest. Small note In Axapta 4.0 only 10G will be supported. Best regards Kim Truelsen EE Axapta